Remove the small wire from between the coil and the distributor. Run two
new wires, one from the coil and one from the distributor to an underdash
toggke switch. At your desired hidden location add an inline fuse holder
and a single throw single pole toggle switch. Connect each end of the fuse
holder to each contact of the toggle switch. Connect the distributor wire
you added to one side of the switch and the coil wire to the other switch
connection. With the switch in the "on" position, the car should start.
The car will also start with the switch in the "off" position, the car will
also start, but will run for only around 10 seconds. Once the fuse is blown,
the car will not run, but can be started by someone returning the switch
to the "on" position, hence the importance of the secret location. Helpful
Hints: *Coil polarity. Hook the coil wire to the distributor using the same
polarity as the battery. If the car is positive ground battery, hook the
positive side of the coil to the distributor. If the car is negative ground
battery, hook the negative side of the coil to the distributor.